Radial Engineering Tonebone Trimode Distortion Pedal
Set up three channels of tone on a single-channel amp!
The 12AX7 tube-equipped Radial Tonebone TriMode Distortion Pedal has true-bypass and 2 distorted channels with separate input drive and output level controls. It allows you to set up completely different clean, rhythm, and solo tones from a single pedal and amp combination. There's even an effects loop on channel 2 so you can insert an effect automatically when soloing. Tonebone pedal features include 3-position tone shaping, drive ranges switches, 2-band EQ, independent mid boost on each channel, and high frequency roll-off.
Tonebone Trimode Distortion Pedal Features
- 12AX7-equipped tube distortion pedal
- True-bypass
- 2 distortion channels
- Separate input drive and output level controls
- Effects loop on channel 2
- 3-position tone shaping
- Drive range switches
- 2-band EQ
- Independent mid boost on each channel
- High frequency roll-off
- TRS effects loop insert on channel 2
- 8"W x 5"H
- 14 gauge steel construction
Â
- Circuit type: Hybrid tube / proprietary circuit
- Tube type Standard 12AX7 vacuum tube
- Input impedance: 1meg Ohm at input jack
- Output impendence: 10K Ohm
- Drive gain
- 3-way switch: Used in conjunction with the drive gain control. Drive switch selects the gain range of the overdrive circuit
- Medium distortion: (+9dB)
- High distortion: (+20dB)
- Intermediate drive: (Intergain™) Variable fine-tune gain for CHANNEL-1 (rhythm) - counter-clockwise for more gain
- Drive-1 & 2 controls: Used in conjunction with the drive gain switch, drive is used to adjust the overall amount of gain to the overdrive circuit
- Mid Boost 1 & 2 - two 3 pos switches: Used to fatten up the sound for more cut and sustain during solos. Also, will fatten up the sound of single coil pickups
- FILTER control: Balances the ratio of high frequencies between amplifier and Classic distortion to compensate for overly bright amplifiers
- TOP END: 3-way switch Switch sets the overall tonal character of the Classic to best match the amp and settings. Brighter amps are normally compensated with darker settings
- Footswitches: True bypass with green on/off status LED
- Toggle 1<>2 with red & yellow status LED's
- LED indicators: Large 3mm OD ultra-bright LED's
- Switching: Opto-coupler assisted, 5msec Rise time
- Construction: 14 gauge steel, baked enamel finish
- Size: 8.12 x 4.25 x 2.12" (207 x 108 x 54mm)
- Weight: 2.55lb (1.16kg)
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Radial Engineering Tonebone Trimode Distortion Pedal Reviews